AutoCommand 20036 Guía de instalación descargar pdf (Pagina 52)

and the serial admit settings.

An Entrance button can also be configured with the following .INI setting to show in the GateKeeper dialog and

can simulate the effect (used for testing only).

[Preferences]

ShowEntranceButton=TRUE

The Entrance button can now be resized and have different text

The settings are:

[Preferences]

ShowEntranceButton=TRUE

[EntranceButton]

X1=.8

X2=1.0

Y1=.03

Y2=.20

Text=Let 'em in

The coordinates are fractions of the dialog size. The Entrance button will simulate an entry through the turnstile

either for serial admission or for serial checkpoint logging.

A delay was added when reading entrances from a serial checkpoint. This is configured in ms:

[Checkpoint]

SerialDelay=100

The default is 100ms (a tenth of a second). This is used to eliminate the extraneous DSR highs generated on a

turnstile rotation. If two (or more) checkpoint entries are getting generated when one person goes through, this

setting may need to be increased to a half or even a full second. The danger of setting it too high is that two people

could go through the turnstile and only one record be generated.

The ability to have two SerialAdmit ports was added. This allows three different channels to generate entries in the

checkpt table. The additional SerialAdmit port is configured as follows:

1 2 ... 47 48 49 50 51 52 53 54 55 56 57 ... 182 183

Sin comentarios

AutoCommand 20036 Guía de instalación Pagina 52