AutoCommand 20036 Guía de instalación descargar pdf (Pagina 117)

117

Special Instructions for installing multiple instances of Pool Service

Each service needs a unique name, in this example it will be SalesEZ-Scanning.

1. Install/create a new service by running the following at a command prompt:

sc create "Siriusware PoolService SalesEZ-Scanning" binpath= "C:\Program

Files (x86)\Siriusware\Pool\poolservice.exe SalesEZ-Scanning"

The binpath must point to your existing Pool folder.

Note: make sure you have a space after the binpath= in the command.

2. Save and unzip the attached modifydacl file, make note of the path where you save it. From the

command prompt, run the attached file, ModifyDACL.exe to set the proper permissions on the service:

C:\ModifyDACL.exe "Siriusware PoolService SalesEZ-Scanning"

3. Close the command prompt.

4. Edit the C:\Program Files (x86)\Siriusware\runexe_system.ini file, In the [Pool

Service ] section, add another line below the SalesEZ= line:

SalesEZ-scanning=SALESEZ_*.EXE

Note: This step may not be necessary because you are actually sharing an .exe with the original SalesEZ install. If

you get an error after updating SalesEZ, then remove this line.

5. Edit the C:\Program Files (x86)\Siriusware\Pool_System.ini file, copy the

[SalesEZ] section and paste it below itself. Change the name of the section to match everything else you

have done and change the ListenPort to be something not in use by the system.

[SalesEZ-Scanning]

Name=salesez40.basic_sales

ListenPort=4205

Pool=3

6. Create a copy of the ServiceMonitor SalesEZ shortcut and change the name to match your new instance.

Edit the properties of the shortcut and change the Target: value to match your new service, you need to

update the information between the [service] [/service] and [port] [/port] tags.

1 2 ... 112 113 114 115 116 117 118 119 120 121 122 ... 182 183

Sin comentarios

AutoCommand 20036 Guía de instalación Pagina 117